Speaker Connections And "Speaker Setup" Settings - Onkyo TX-NR686 Instruction Manual

Speaker Connections and "Speaker Setup" Settings

Connections
„ (Note) Speaker Impedance
Connect speakers with an impedance of 4 Ω to 16 Ω. If any of the speakers to
be connected has an impedance of 4 Ω or more and 6 Ω or less, the setting is
required in the Setup menu after the Initial Setup (
on the remote controller, and set "2. Speaker" - "Configuration" - "Speaker
Impedance" to "4ohms".
„ Connect the Speaker Cables
1/2˝
(12 mm)
Contents
Make correct connection between the unit's jacks and speaker's jacks (+ side to
+ side, and - side to - side) for each channel. If the connection is wrong, a bass
sound will not be reproduced properly due to reverse phase. Twist the wires
exposed from the tip of the speaker cable so that the wires do not stick out of the
speaker terminal when connecting. If the exposed wires touch the rear panel,
or the + side and – side wires touch each other, the protection circuit will be
p116) is completed. Press
activated.
20
Connections
≫ ≫
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫