Flashing The Example Program On The Rsk-Rx65N-2Mb Board; Figure 2. Creating A New Project On Renesas Flash Programmer; Figure 3. Enabling Auto Authentication - Renesas RX600 Series Quick Start Manual

Renesas RX Family

5.1 Flashing the Example Program on the RSK-RX65N-2MB Board

1. Connect the Mini-B connector of the USB device cable to the USB mini-B port (G1CUSB0) of the
RSK-RX65N-2MB board. Next, connect the USB-A end of the device cable to the host PC.
2. Connect the E2 Lite ribbon cable between the E2 Lite Debugger and the RSK-RX65N-2MB board E1/E2
Lite connector. Connect the Mini-B end of the second USB device cable to the E2 Lite Debugger and the
Type-A end to the host PC.
3. Connect the power cable from the AC adapter to the power jack on the RSK-RX65N-2MB board (PWR).
4. Open Renesas Flash Programmer and create a new project by using the File menu and selecting New
Project.
5. In the Create a New Project window, select the RX65x from the Microcontroller drop-down menu. Next,
enter a desired project name and select E2 emulator Lite for the Communication Tool and Interface as
2 wire UART. Click Connect.

Figure 2. Creating a New Project on Renesas Flash Programmer

6. An authentication window should appear. Then, enable Auto Authentication and click OK.
7. Verify that the message Operation Completed is printed in the main window. Under Program File, click
Browse to choose to the program file that will be flashed onto the board (Figure 4). Using the file
explorer window, navigate to the example project's Hex File (located in r21qs0009euxxxx-ryz024a-rsk-
rx65n-2mb.zip > ryz024a_quickstart_rx65n_2mb/ ryz024a_quickstart_rx65n_2mb.hex) and click
Open.
R21QS0009EU0100 Rev.1.00
Feb.22.23

Figure 3. Enabling Auto Authentication

RSK-RX65N-2MB – Quick Start Guide
Page 8 of 18