Introduction; Assumptions And Advisory Notes; Kit Contents; Rsk-Rx65N-2Mb Kit Setup - Renesas RX600 Series Quick Start Manual

Renesas RX Family
Figure 10. Board Information ......................................................................................................................... 12
Figure 11. RYZ024A PMOD Information ....................................................................................................... 13
Figure 12. Validation Steps of SIM Activation ............................................................................................... 13
Figure 13. Validating SIM Activation – SIM Card Active ............................................................................... 14
Figure 14. Activating the SIM Card ................................................................................................................ 14

1. Introduction

This Quick Start Guide (QSG) provides:
•
An overview of the RYZ024A PMOD example project for the RSK-RX65N-2MB board.
•
Instructions for running the RYZ024A PMOD example project on the RSK-RX65N-2MB board.
•
Instructions for flashing the RYZ024A PMOD example project code using Renesas Flash
Programmer.

1.1 Assumptions and Advisory Notes

1. Tool experience: It is assumed that the user has prior experience in using a serial terminal
emulation program such as Tera Term.
2. Subject knowledge: It is assumed that the user has basic knowledge about microcontrollers,
embedded systems, LTE communication and AT commands.
3. The screen shots provided throughout this document are for reference. The actual screen content
may differ depending on the version of software and development tools used.

2. Kit Contents

The following components are required:
1. RYZ024A PMOD board with external antenna (RTKYZ024A0B00000BE)
2. RSK-RX65N-2MB board (RX65N-2MB-Starter-Kit-Plus)
3. E2 Lite Debugger (RX5N-2MB-Starter-Kit-Plus)
4. 5VDC power supply (RX65N-2MB-Starter-Kit-Plus)
5. 2x USB device cables (type-A male to mini-B male)
6. 1x USB cable (type-A male to micro-B)
7. Truphone SIM card (RTKYZ024A0B00000BE)

3. RSK-RX65N-2MB Kit Setup

First, disconnect the 5VDC power from the board. The RYZ024A PMOD board should be connected to
PMOD1 with the external antenna attached (Figure 1). The included SIM card must be inserted in the card
slot on the underside of the RYZ024A PMOD board. Connect the micro USB cable to RYZ024A PMOD
board (connector CN4) for external powering of PMOD and the other end of cable to a PC USB port. You
may now reconnect the 5VDC power cable.
R21QS0009EU0100 Rev.1.00
Feb.22.23
RSK-RX65N-2MB – Quick Start Guide
Page 6 of 18