Furuno INMARSAT-C FELCOM 18 Operator's Manual page 34

3. SYSTEM INITIALIZATION
4. Press the Enter key to close the window. (Note that the IMN is entered during in-
stallation. The IMN window cannot be opened.)
5. Select [MES Operation Mode] then press the Enter key to show the MES Opera-
tion window.
6. Select an operating mode, [INMARSAT-C] or [EGC]. The INMARSAT-C setting
provides telex communications and operates as an EGC receiver when the equip-
ment is not transmitting or receiving. The EGC setting enables EGC-only opera-
tion. In this case, "Current State: EGC RECEIVER" appears (reverse video) at the
bottom of the screen.
7. Press the Enter key to close the window.
8. Select [NAV Port] then press the Enter key.
9. Select the navigator connected to the FELCOM then press the Enter key.
OFF: Manually input the position of own ship. Alarm is outputted when the position
data is not updated every four hours.
Auto: INT or EXT is automatically selected. For SSAS Russia and LRIT Russia,
the setting of [NAV Port] is fixed at Auto and GLONASS is prioritized.
INT: Use the navigator that is built into the terminal unit.
EXT: Use an external navigator.
Note: If the system is not fitted with the internal GPS receiver and there is no ex-
ternal GPS receiver, turn off the [NAV PORT] setting and enter position manually,
on the [Position] menu. See section 3.8.
10. Select [LAN Port] then press the Enter key.
11. Select [ON] to enable LAN interface or [OFF] to disable it then press the Enter
key.
12. Select [Message Output Port] then press the Enter key.
13. Select the destination for sent messages then press the Enter key.
INT: Output messages to the main terminal.
LAN: Output messages to the LAN. ([LAN Port] set to [ON])
INT+LAN: Output messages to both the main terminal and the LAN. ([LAN Port]
set to [ON])
AUTO: All received messages are output according to the message sub address.
14. Select [EGC Output Port] then press then Enter key.
15. Select where to route received EGC messages then press the Enter key.
INT: Output EGC messages to the main terminal.
LAN: Output EGC messages to the sub terminal or other navigation device con-
nected to the LAN Port on the main terminal.
INT+LAN: Output EGC messages to the main terminal, sub terminal and other
navigation device.
16. Press the Esc key to open the [Update] window.
Note: [Network Setup] provides network initial settings. [Command Window] is no
use.
17. [Yes] is selected; press the Enter key to update the system settings.
18. Long-press the Esc key to return to the standby display.
3-2