Advertisement
Removing the Discharge Chute
1. Remove the locknut
spacer
pivot brackets.
2. Remove the grass deflector.
Note:
during this procedure so that it is available for
changeover.
Drilling Holes
For G3 Mower Decks
Using a drill without proper eye protection may allow debris to enter the eye, causing
injury.
When drilling, always wear eye protection.
1. Check the hole diameters in the locations shown.
2. If there are no holes in the side discharge
mounting bracket
as a template and mark the location of the
holes.
Note:
part of the slot to mark the location of the hole.
This will allow for clearance of the nut when
the discharge plate is installed.
3. Drill 2 holes (7/16 inch)
3465-647A
, bolt
holding the grass deflector
Retain the hardware that you removed
, use the discharge plate
For the upper rear hole, use the upper
.
, spring
, and
to the
G428583
WARNING
G428784
Page 3
Advertisement
