Advertisement
5
Removing the Existing
Discharge Chute
No Parts Required
Procedure
1.
Remove the locknut, bolt, spring, and spacer
holding the deflector to the pivot brackets
(Figure
5).
2.
Remove the grass deflector
Note:
Retain the hardware that you removed
during this procedure so that it is available for
changeover.
1. Bolt
2. Spacer
3. Locknut
4. Spring
(Figure
5).
Figure 5
5. Spring installed
6. Grass deflector
7. J-hook end of spring
6
Drilling Holes
For G3 Mower Decks
No Parts Required
Procedure
1.
Check the hole diameters in the locations shown
in
Figure
2.
Drill the holes to the specified diameter in the
locations shown in
g015594
1. Drill this hole to 3/8-inch
diameter
6
6.
Figure
6.
Figure 6
2. Drill this hole to 7/16-inch
diameter
g010808
Advertisement
