Controlling Multiple Projectors; Setting The Projector Id - Epson PowerLite 835p User Manual

note
By default, the remote
control's ID is set to zero,
which allows it to control
any projector. If you want to
control multiple projectors
simultaneously, and you
don't want to switch
between them (each
projector would need its own
screen), you can leave the
remote control's ID set to
zero.
Fine-Tuning the Projector
132

Controlling Multiple Projectors

If you're using more than one projector for your presentation, you can
switch between them using a single remote control. To do this, you
need to set a different ID for each projector. During the presentation,
you can change the remote control's ID to match that of the projector
you want to use.

Setting the Projector ID

The projector's default ID is 1. Follow these steps to change it:
1. Press the button on the remote control.
Menu
You see the projector's menu screen.
2. Select the
Extended
3. Highlight
Projector ID
4. Choose an ID value for the projector and press
5. When you're done, press
menu and press .
Enter
and press .
Enter
to exit the menu system.
Esc
.
Enter