Epson PowerLite 835p Quick Setup

1

Turn On Your Equipment

1
Connect the power cord to the back of
the projector and plug the other end
into a grounded outlet.
2
Remove the lens cover.
3
Remove the battery cover on the remote
control. Locate the batteries that came
with the projector and insert them as
shown. Then replace the battery cover.
4
Push up the remote control's ON/OFF
switch to turn it on.
5
To turn on the projector, press the red
or the remote control. The projector beeps once, and the projector's
Power light flashes green and then stays on.
CAUTION: Before unplugging the projector...
Shut the projector down properly:
1. Press the
Power light flashes orange (about 30 seconds).
2. Once the light stops flashing and stays on, it's safe to unplug
the projector.
2

Adjust the Image

1
To raise the image, press the blue foot release button for the front
adjustable foot and lift the front. Release the button to lock the
foot in position.
EPSON
Power button twice. Let the projector cool while the
PowerLite
®
Quick Setup
Power button on the projector
835p
®
ON/OFF
switch