Epson PowerLite 835p User Manual page 70

note
The projector keyword
changes each time you turn
the projector off and then on
again, or remove and
reinsert the 802.11g card.
Check the keyword on the
EasyMP Network screen
whenever you start EasyMP,
and enter that keyword on
your computer. You can't
connect using a previous
keyword.
note
For specific details about
your network, please consult
your network administrator.
If you don't know your
gateway or access point
address, see page 76. If you're
using AirPort, start the
AirPort Admin utility, select
your base station and click
. Then click the
Configure
tab to see your
Network
base station's IP address.
Presenting Through a Wireless Network
70
5. To enable your computer to find the projector on the network,
you need to enter an ESSID, which is the SSID name of your
access point or the name of your AirPort network. (The name of
your AirPort network may be different from that of your AirPort
base station; select your base station in the AirPort Admin utility
and click
Configure
Highlight the
ESSID
When you're done, press
case-sensitive (if you enter the name in uppercase on the
projector, you must type it the same way on the computer
connecting to the projector).
6. If you want to create a password for remote access to the
projector, highlight the
press , and enter a password of up to 8 alphanumeric
Enter
characters. When you're done, press
7. If you want to set up a security keyword so that only people who
are in the same room as the projector can access it, turn
on. Then when you want to connect to the projector, it
keyword
displays a randomized four-digit number or "keyword" on the
screen. When prompted by NS Connection, you can enter the
keyword on your computer to connect (see page 86).
8. If your access point assigns IP addresses automatically, turn on
. Otherwise, turn off DHCP and enter the following
DHCP
information manually:
■ : Type in the IP address you want to assign to the
IP address
projector. It must be formatted like other addresses on the
network; the first two segments (XXX.XXX) should match
the first two segments of the IP address for your access point
or AirPort base station. The last segment should be unique.
■ Subnet mask
depends on how your network is set up.
■
Gateway address
the access point or AirPort base station when it was set up.
to check the name of your network.)
text box, press
Enter
. Note that the ESSID is
Enter
Password for WEB control
Enter
: For example: 255.255.255.000, but this
: Enter the IP address that was assigned to
, and enter a name.
text box and
.
Projector