Epson PowerLite 835p User Manual page 75

10. If your access point uses DHCP, select
. Otherwise select
automatically
and enter the required information:
■ : Type in the IP address you want to assign to the
IP address
computer. It must be formatted like other addresses on the
network; the first two segments (XXX.XXX) should match
the first two segments of the access point's IP address and the
last segment must be unique.
■ Subnet mask
depends on how your network is set up.
■ Default gateway
the access point when it was set up.
11. When you're done, click
12. Click the
Wireless Networks
(If you don't see this tab, you may need to enable your wireless
card or adapter by clicking
settings; then follow any instructions on the screen to enable the
device.)
You see a screen like this:
Obtain an IP address
Use the following IP address
: For example: 255.255.255.000, but this
: Enter the IP address that was assigned to
.
OK
tab.
to access the device
Configure
note
For specific details about
your network, please consult
your network administrator.
note
If you don't know your
gateway or access point
address, see page 76.
Presenting Through a Wireless Network
75