Controlling Multiple Projectors; Managing Projectors From A Remote Computer - Epson PowerLite 9300i Quick Manual

EPSON PowerLite 9300i Projector

Controlling Multiple Projectors

If you're using more than one projector, you can control all
the projectors—or just selected ones—by using the projector
ID system. To operate a projector, you have to set the remote
control's ID to match that of the projector. Or you can
control all of the projectors simultaneously by setting the
remote control's ID to zero.
Setting the Projector ID
The projector's default ID is 1. If you need to change it,
follow these steps:
1. Access the projector's
Advanced2
.
Projector ID
Video
Projector ID
Audio Network
Effect COM Port
Setting Auto Setup
User's Logo BNC Sync Termination
Direct Power ON
Advanced1
Advanced2 Reset
About
Reset All
[ ]: Select [ ]: Enter
2. Press the right or left side of the
remote control to increase or decrease the ID value.
3. Press to set the value.
Enter
4. When done, press
ESC
Setting the Remote Control ID
The remote control's default ID is zero. To change it:
1. Press the button on the remote control.
ID
You see it light up.
2. Press one of the numbered buttons on the
remote control to select the desired ID (0
through 9). Select zero to control all
projectors, or select a number to match the
ID of the projector(s) you want to operate.
The button's light shuts off and the new ID is registered.
ID
If you would like to check the remote control's current ID,
press the button twice in succession. Count the number of
ID
flashes; this number corresponds to the remote control's ID.
(If it doesn't flash, it is set to zero.)
12 EPSON PowerLite 9300i Projector
-
menu and highlight
: 1 :
Set
Set
: RS-232C USB
:
ON OFF
:
ON OFF
:
ON OFF
Execute
[Menu]: Exit
pointer button on the
to exit the menu system.
Nine
Zero
0
Managing Projectors from a Remote
Computer
The EasyManagement software lets you monitor and control
projector(s) from a remote computer. These features are
intended for use by network administrators.
Use EMP Monitor to see your projectors' status, switch
image sources, and control basic settings.
Use EMP NetworkManager to receive e-mail notifications
alerting you to possible problems.
Use EMP Multi Screen Adjustment to make your image
appear consistent when you are combining multiple
projectors to display a single, large image.
Make sure you install the software (included on the projector's
CD-ROMs) on the computer you want to use to monitor
your projectors.
Setting Up the Network
Connect each projector you want to monitor to your network
and configure it with an appropriate IP address.
1. Connect the projector to your network using a
commercially available 100baseTX or 10baseT network
cable.
Ethernet port
To network port
2. Turn on the projector.
3. Press the
Menu
from the
Network
Video
Audio
Effect
Setting
User's Logo
Advanced1
Advanced2
About
Reset All
[ ]: Select [ ]: Enter
10/03
button on the remote control and select
menu.
Advanced2
: : 1
Projector ID Set
Set
Network
COM Port : RS-232C USB
Auto Setup :
ON OFF
BNC Sync Termination :
ON OFF
:
Direct Power ON ON OFF
Reset
Execute
[Menu]: Exit
Select
Network