Viewing Lamp Usage and Other Information
Use the Info menu to view information about the display settings of
your computer and the number of hours the lamp has been used.
Press the
button and highlight the
Menu
You see the lamp usage hours and various input signal settings on the
right.
The life span of the lamp is about 2000 hours if the
setting in the Setting menu is set to
Control
hours if the
Brightness Control
have a spare lamp handy if the usage hours on this menu are close to
the life span of your lamp.
Solving Problems with the Image
or Sound
No image appears on the screen.
Check that the
■
Power
cap is off.
The projector may be in Sleep Mode. If the
■
orange, press the P
If the power was switched off and then on again, the projector
■
may be cooling down. Wait until the
and remains orange; then press the P
Press the
■
A/V Mute
turned off temporarily.
The attached computer may be in sleep mode or displaying a
■
black screen saver. Try pressing a key on the computer.
You've connected a computer and see a blue screen with the
message
displayed.
No Signal
■
Make sure the cables are connected correctly, as described on
page 46.
Info
High
setting is set to
light is green, not flashing, and the lens
button to turn the projector on.
Power
Power
Power
button to make sure the picture has not been
menu.
Brightness
(default), and 3000
. Make sure you
Low
light is
Power
light stops flashing
button again.
note
The information displayed
depends on the input signal
currently selected.
Solving Problems
171