Siemens SIMATIC IPC647E Operating Instructions Manual page 127

Installing a new drive
1. Attach the drive rails ③ to the new drive. The connector area ① points to the two clips ②.
2. Insert the drive into the drive bay from the front. The connector area points into the interior
of the device.
3. Slide the drive into the device until the drive clicks into place.
4. Connect all lines in the connector area ①.
5. Replace the cover on the front of the device.
To do this, first hang the cover with the right side in the notches provided.
Then close the cover on the left.
6. Close the device.
SIMATIC IPC647E
Operating Instructions, 09/2022, A5E52254141-AA
Expanding and assigning parameters to the device
6.6 Installing and removing drives
127