Siemens SIMATIC IPC647E Operating Instructions Manual page 129

5. Mount the mounting bracket to the sides of the new drive.
When attaching the mounting bracket, make sure that the notch on the mounting
brackets faces the bottom of the drive.
Figure 6-2
Figure 6-3
6. Tighten all screws on the two mounting brackets. Tighten the screws on the notches first
(tolerance compensation).
7. Place the drive in the opening at the top of the drive cage. The notches on the mounting
brackets point upwards, i.e. the top of the drive points towards the drive cage.
8. Screw the mounting bracket to the top of the drive cage using the 4 screws previously
removed.
SIMATIC IPC647E
Operating Instructions, 09/2022, A5E52254141-AA
Mounting bracket with 1 drive (for drive cage type A and type B)
mounting bracket with 2 drives (for drive cage type B)
Expanding and assigning parameters to the device
6.6 Installing and removing drives
129