Viewing And Changing Media Settings - Epson SureColor F7170 User Manual

Viewing and Changing Media Settings

The control panel displays the following information once the media is loaded.
This display can be used to view or change the following two options:
❏ Remaining Setup
On: The printer displays the amount of media remaining.
Off: The printer does not display the amount of media remaining.
When Remaining Setup is On, the printer will calculate the approximate amount of
media remaining based on the length of the roll and the amount used for printing and
display this information in the control panel. The display gives a rough idea of the
amount of media available before printing, making it easier to know when media
requires replacement.
In addition, a warning will be displayed when the amount of media remaining reaches a
specified level.
❏ Selected Media
Displays the parameters on which media settings are based as shown below.
RIP Settings: Media settings are based on those in the RIP.
XXXXXXXXXXXXXXXXXX: Media settings are based on those stored in the printer
in media settings bank No. 1.
Media settings banks can store a variety of settings for different media based on the
options selected in the Media Suction, Head Alignment, and other menus. Up to 30
combinations of settings can be stored by assigning them to banks No. 1 to 30. Using
the printer's media settings is recommended.
Basic Operations 43