Advertisement
Step 12 Attach Ground Stakes and Slide
WARNING! DIGGING CAN BE DANGEROUS. CHECK FIRST FOR
UNDERGROUND WIRING, CABLES, OR GAS LINES ETC.
•Use a scrap wood piece in between the top of the Ground Stake and the Sledge Hammer to protect the
stake from damage.
•Stakes are to be secure to the posts and the ground.
•Firmly anchor unit to ground before use.
•Check for looseness, re-secure and replace if necessary.
•DO NOT USE CONCRETE OR OTHER MATERIALS FOR ANCHORING STAKES!
Using 2 Pan Screws (#12 x 2"), attach Slide making sure that screws go through the Floor Board and into the SL Brace .
The SW Post hole will be dug out 6" wide x 6" long x 2" deep into the ground.
Note:
Using 2 Wood Screws (#8 x 2-1/2") per Ground Stake, attach Ground Stake (2 x 2 x 14") to each post as illustrated below.
MAKE SURE GROUND AND FORT ARE LEVEL PRIOR TO DIGGING AND STAKE DRIVING.
SW Post
#8 x 2-1/2"
Wood Screw
Ground Stake
2" x 2" x 14"
Ground Stakes
must be driven
a minimum of 10½"
into ground before
attaching to post.
Ground Stake
Location #4
SW Post Hole
Dig 2" Deep
Ground Stake
Location #1
#12 x 2"
Pan Screw
SL
Brace
Ground Stake Location #2
HARDWARE LIST
2 pcs #12 x 2" Pan Screw
8 pcs #8 x 2½" Wood
Screw
WOOD PARTS LIST
4 pcs 2x2x14" Ground
Stake
ACCESSORY LIST
1 Slide
Square
Assembly
Ground Stake
Location #3
Advertisement
