Advertisement
Step 9 Assemble Swing Hangers and Triangle Plate
Insert 4 Bolt Hangers with flat washers into the CE SW Rail (2" x 6" x 71") holes from the
bottom edge of the beam, making sure that the Bolt Hangers are
Add flat washer and lock nut from the top of the CE SW Rail. Tighten the bolt hangers to the CE SW Rail.
Using 2 Hex Bolts 1/4" x 5 1/2" (1/4" T-Nut, Flat Washer, and Lock Washer),
attach one bolt to each end of CE SW Rail (2" x 6" x 71").
Note: These bolts do not attach to anything, rather, they serve to provide additional strength to the SW
Beam. THIS STEP IS MANDATORY.
Using 1 Hex Bolt 5/16" x 1 1/2" (5/16" T-Nut, Flat Washer, and Lock Washer), attach 1 Triangle Plate to the
Make sure
CE SW Rail (2" x 6" x 71").
Flat Washer
Bolt Hanger
!
Warning! Bolt Hangers must be
tightly installed to CE SW Rail.
Follow Proper Assembly Procedure
CE SW Rail
Swing
Hanger
to use the correct hole in the Triangle Plate. Refer to the diagram below.
Lock Nut
Flat Washer
CE SW Rail
2" x 6" x 71"
Swing Hanger
orientation
for Swing Hanger
Tighten Hanger in until
Swing
it is tight and flush with
bottom of Swing Beam
Hanger
flush
with the bottom of the CE SW Rail.
Make sure
Label faces
outward
5/16" x 1 1/2"
Hex Bolt
1/4" x 5 1/2"
Hex Bolt
HARDWARE LIST
2 pcs 1/4x5-1/2" Hex Bolt
2 pcs 1/4" T-Nut
2 pcs 1/4" Flat Washer
2 pcs 1/4" Lock Washer
1 pc 5/16x1-1/2" Hex Bolt
1 pc 5/16" T-Nut
1 pc 5/16" Flat Washer
1 pc 5/16" Lock Washer
4 pcs Bolt Hanger with
hardware
WOOD PARTS LIST
1 pc 2x6x71" CE SW Rail
ACCESSORY LIST
Triangle
1 pc Triangle Plate
Plate
1/4" x 5 1/2"
Hex Bolt
CORRECT
INCORRECT
REMEMBER TO USE THIS ASSEMBLY
PROCEDURE FOR HEX BOLTS
T-NUT
LOCK WASHER
HEX BOLT
FLAT WASHER
Advertisement
