Advertisement
Step 8 Assemble Swing End
Using 1 Hex Bolt 5/16" x 4 " (5/16" T-Nut, Washer, and Lock Washer), attach loosely leaving a gap
between the Post SW (5/4" x 4" x 81") and the SW Post (2" x 4" x 80-1/2") as shown in the diagram below.
Using 1 Hex Bolt 5/16" x 4 1/2" (1/4" T-Nut, Washer, and Lock Washer),
attach the Floor Support (5/4" x 4" x 39 1/2") to the SW Post (2" x 4" x 80-1/2"),
as shown in the diagram.
Using 2 Hex Bolts 1/4" x 2" (1/4" T-Nut, Washer, and Lock Washer), attach
the Floor Support (5/4" x 4" x 39 1/2") to the Post SW (5/4" x 4" x 81").
Using 2 Wood Screws (#8 x 2-1/2") attach 1 SW Block (5/4" x 4" x 3 1/2") to bottom of
the SW Post. Refer to the diagram below.
REMEMBER TO USE THIS ASSEMBLY
PROCEDURE FOR HEX BOLTS
LOCK WASHER
HEX BOLT
T-NUT
FLAT WASHER
5/16 x 4"
Hex Bolt
Post SW
5/4" x 4" x 81"
NOTE! Do not tighten the Hex Bolt until
after the Floor Support is attached
SW Post
2" x 4" x 80-1/2"
HARDWARE LIST
2 pcs 1/4x2" Hex Bolt
2 pcs 1/4" T-Nut
2 pcs 1/4" Flat Washer
2 pcs 1/4" Lock Washer
1 pc 5/16x4-1/2" Hex Bolt
1 pc 5/16x4" Hex Bolt
2 pc 5/16" T-Nut
2 pc 5/16" Flat Washer
2 pc 5/16" Lock Washer
2 pcs #8x2-1/2" Wood Screw
WOOD PARTS LIST
1 pc 5/4x4x39-1/2" Floor Support
2 pcs 5/4x4x81" Post SW
1 pc 2x4x80-1/2" SW Post
1 pc 5/4x4x3-1/2" SW Block
1/4 x 2"
Hex Bolt
Post SW
5/4" x 4" x 81"
Floor Support
5/4" x 4" x 39-1/2"
5/16 x 4-1/2"
Hex Bolt
#8 x 2-1/2"
Wood Screw
SW Block
5/4" x 4" x 3-1/2"
Advertisement
