Advertisement
Step 11 Attach Swing End to Fort
MOVE THE FORT TO FINAL LOCATION AND MAKE SURE GROUND AND FORT ARE LEVEL.
Using 2 Hex Bolts 5/16" x 1 1/2" (5/16" T-Nut, Flat Washer, and Lock Washer) and 1 Hex Bolt 5/16" x 3"
(5/16" T-Nut, Flat Washer, and Lock Washer), and 1 Triangle Plate attach the Fort to the Swing End.
Using 1 Wood Screw #8 x 2 1/2", attach the CE SW Rail to the SW Post.
Make sure to use correct holes in the Triangle Plate as illustrated below.
Remember to use the proper assembly procedure for the Hex Bolts.
Note: Tighten all Hex Bolts from previous steps.
A 6 feet safety clearance must remain around the fort prior to use.
5/16" x 3"
#8 x 2 1/2"
Hex Bolt
Wood Screw
5/16" x 1 1/2"
Hex Bolt
CORRECT
INCORRECT
Notice: Canopy has
been removed for clarity.
Do not remove.
5/16" x 1 1/2"
Hex Bolt
HARDWARE LIST
1 pc 5/16x3" Hex Bolt
2 pcs 5/16x1-1/2" Hex Bolt
3 pcs 5/16" T-Nut
3 pcs 5/16" Flat Washer
3 pcs 5/16" Lock Washer
1 pc #8x2½" Wood Screw
ACCESSORY LIST
1 pc Triangle Plate
Use
Help
NOTE: An adult helper
may be required for this step.
REMEMBER TO USE THIS ASSEMBLY
PROCEDURE FOR HEX BOLTS
LOCK WASHER
HEX BOLT
T-NUT
FLAT WASHER
Advertisement
