Basic End-Point Module Configuration - Thermo Scientific Smart-Vue Installation Manual

Basic end-point module
configuration
Thermo Fisher Scientific
If this test does not show a wireless signal, please refer to the Thermo
Scientfic Smart-Vue Software User Manual for instructions on adding
end-point modules into the system manually.
Smart-Vue end-point modules offer a variety of data-logging, alert and
transmission options. This section describes the basic settings to get started
right away. Please see the complete Thermo Scientific Smart-Vue Software
User Manual for more details.
Moving the Smart-Vue end-point module into a group
1. Launch Smart-Vue Client on your computer and enter your login
name and password to continue. The new Smart-Vue end-point
module should be listed as shown here, where "local" refers to the
receiver and "SDP-local" refers to a generic group for new
un-configured end-point modules connected to that receiver.
Figure 7. Example with new dry contact end-point module in the
generic "SDP" group
2. Press F11 or select Settings ==> Sensor settings (
when prompted.
3. You may choose to click on Modify Sensor Name to assign replace
the numeric end-point module address with a user-friendly name
(e.g., Dry Contact 1).
The name on the end-point module's LCD is refreshed every 24 hours
(maximum) to preserve battery life. Thus, name changes may not be shown
immediately, but they are taken into account in the software.
Smart-Vue Dry Contact Module Installation Guide
Software configuration
), and log in>
13