Typical Installation - Thermo Scientific Smart-Vue Installation Manual

What is a Smart-Vue wireless end-point module?

Typical installation

Smart-Vue end-point modules transmit remote readings and alerts to a PC
running Thermo Scientific Smart-Vue Server/Smart-Vue Client software
equipped with a wireless receiver. The receiver may also be located remotely
from the PC on a TCP/IP receiver installed directly on an Ethernet
network. Repeaters may be used when the wireless range between the
receiver and the Smart-Vue end-point module is too great to achieve a
strong signal. The diagram below shows these basic configurations:
Figure 2. Typical Smart-Vue wireless configurations
NOTE: Be sure to configure each end-point module (and repeater, if
applicable) to connect to one receiver only, as shown above in Figure 1. Any
given end-point module can only be read by one receiver.
Smart-Vue end-point modules for dry contact monitoring are generally
installed in a convenient location at room temperature.
Smart-Vue Dry Contact Module Installation Guide
Thermo Fisher Scientific 5