Table of Contents
Advertisement
October 2007
Preinstallation procedures
LinkPlexer 6.0 requires the following preinstallation procedures:
TCP/IP must be configured and working prior to beginning the LinkPlexer
installation. For information, see the system administrator's manual for
Microsoft Windows 2003.
Microsoft Windows Server 2003 must be installed on the PC.
Nortel recommends that pcAnywhere 11.5 is installed on the PC prior to
installing LinkPlexer 6.0.
An ICM or CompuCALL line to the switch must be in place. For more
information, see the ICM TAPI Network Manager's Guide.
If using the X.25 network protocol to communicate with the CS 2x00/DMS
switch, you must complete the hardware and network configuration prior to
installing LinkPlexer 6.0. For more information, see Chapter 4, "Installing
and configuring the Eicon X.25 card" and Chapter 7, "Configuring and
maintaining LinkPlexer 6.0."
Installation and Configuration Guide
Installation overview
33
Advertisement
Table of Contents
