Table of Contents
Advertisement
October 2007
Configuring Contact Center Manager Server to
use LinkPlexer 6.0
The following section describes the procedure used to configure Contact Center
Manager Server to use LinkPlexer.
To configure Contact Center Manager Server to use the LinkPlexer 6.0
application
1
On the Contact Center Manager Server, click Start > All Programs >
Nortel Contact Center > Manager Server > Feature Report.
Result: The Feature Report dialog box appears.
2
Select the Switch Information tab.
3
In the Switch Name box, type a name for the switch.
4
In the Switch IP Address box, type the IP address of the LinkPlexer 6.0
server.
Note: Contact Center Manager Server assumes the port number is 2500.
Installation and Configuration Guide
Configuring and maintaining LinkPlexer 6.0
109
Advertisement
Table of Contents
