Nortel CC MIS Release Note page 64

Installation overview
Installing the CC MIS application on a server for the first time
To install the CC MIS application on a new Linux server, you must log on to
the server as the root user. The installation requires the careful use of several
Linux commands to extract the application software from the CD-ROM and
execute the supplied installation script. The installation procedure is
documented in CC MIS Installation and Maintenance (297-2671-545).
A CC MIS keycode is required to complete the installation of the CC MIS
software. If the keycode is not available at the time of installation, the
CC MIS software is disabled until a valid keycode is installed in the system
through the CC MIS Maintenance interface (using the Install License
Keycode command on the System Upgrade Utilities menu).
Upgrading a server already running CC MIS
To upgrade the CC MIS server software, you must use the Load New
Software Version command on the System Upgrade Utilities menu. Failure
to perform the upgrade using this method can result in a corrupted system.
A new keycode is not required for software upgrades unless the major
release version of the new software release is higher than the existing
software.
Migrating data from older CC MIS systems
You can migrate CC MIS databases from the older CC MIS platforms
(PowerPC and RISC) using the Import function on the Backup and Restore
Utilities menu of the CC MIS Maintenance interface. This function is new
to CC MIS Release 6.0 and requires the source system (the CC MIS server
containing the data to be imported) to be running CC MIS Release 5.2 or
later. For details about importing data, see CC MIS Installation and
Maintenance (297-2671-545).
64 Call Center Management Information System
Standard 2.0