Nortel CC MIS Release Note page 56

Software release history
Release 6.0
Support for the PowerPC and Reduced Instruction Set Computer (RISC)
platforms is discontinued in CC MIS Release 6.0.
Maintenance interface
CC MIS Release 6.0 provides the following changes and enhancements:
Direct X.25 connection to the switch is not supported. Links to the
switch must be made using a TCP/X.25 bridge device, configured to
provide an IP-to-X.25 bridge. You cannot configure X.25 switch links on
Linux systems. Instead, you can define live TCP/IP switch links and
simulator links.
Backup to a tape drive is not supported. Instead, you use a user-specified
directory to back up CC MIS. You can configure the directory to point to
any device that can be mounted as a Linux file system, including an
additional hard disk, a Network File System (NFS)-mounted file system,
or any other network storage device that can be configured as a file
system.
CC MIS does not use printers configured on the CC MIS server for
printing reports generated within a customer partition. The Microsoft
Windows printer interface provides a standard interface for printing
CC MIS reports. Printing functionality in the CC MIS Maintenance and
Administration interface is directed to the system default printer. The
current set of configuration reports available within the CC MIS
configuration utility can be printed to any client-attached printer, sent to
an e-mail address (if Sendmail is configured), or saved as a text file on
disk.
With some exceptions, CC MIS permits host names to be entered
anywhere an IP address can be entered. The use of host names requires
that a name resolution protocol be configured on the server (DNS or
NIS).
56 Call Center Management Information System
Standard 2.0