Nortel CC MIS Release Note page 63

May 2007
Installation of the CC MIS server software
For complete details about installing and configuring the CC MIS server
software, see CC MIS Installation and Maintenance (297-2671-545).
Preinstallation verification
Before you install the CC MIS server software, you can check the target
server platform for suitability by running the preinstallation script located in
the lnx directory on the CC MIS Software CD-ROM. The preinstallation
script is noninvasive; that is, it makes no changes to the target system. The
script checks that the target server has all required software packages
installed and that appropriate disk partitions are available for CC MIS. If
any configuration errors or warnings are detected, the script provides
guidance on how to correct the problems. After you correct any problems,
you can run the preinstallation script again to verify that the changes made
satisfy the CC MIS installation requirements.
Note: Ensure that the preinstallation script completes without any errors.
The preinstallation script is invoked a second time during installation and
cancels the installation if any errors are detected.
The preinstallation script also provides the system serial number, which is
derived from the last 4 bytes of the MAC address of the first network
interface card (NIC) in the system. This system serial number is required to
generate the unique CC MIS keycode that unlocks the feature set that was
purchased for this system.
For complete details about the requirements for the CC MIS server,
preinstallation requirements, and the use of the preinstallation script, see CC
MIS Installation and Maintenance (297-2671-545).
Release Notes
Installation overview
63