Installation; Site Preparations; Minimal Site Dimensions & Mounting Holes - FLOWBIRD CWT S5 Installation & Maintenance Manual

Product description
Connector Com port
J33
J34
J35
J36
J37
J38
J39
J40
J41
J42
J44
J45
J47
J48
J49
(* J35 cannot be used if the MDB port (J37) is used and vice versa
(** Only if an expansion board with a serial connector is installed

Installation

5
Flowbird strongly recommend the following conditions and settings to be
considered when planning and installing solar operated CWT S5 terminals.
Deviations from the guidelines will result in lower efficiency from the solar panel
which may lead to operational issues depending on location, configuration,
maintenance and usage frequency.
5.1

Site preparations

Before installing a terminal, you must verify that its location meets the
requirements listed in the following section to secure proper operation.
5.1.1
Minimal site dimensions & Mounting holes
The given distances between fixed objects at the back and the sides of the
terminal are minimum recommended distances:
·
The distance behind the terminal enables easy handling while mounting the
terminal and some vertical adjustment of the terminal. This distance is
Issue 5
Type
Com 3 (* Internal iMX53 UART External pay unit or bill reader - Serial 1
Com 3 (* Internal iMX53 UART External pay unit or bill reader - MDB
Battery voltage
CWT S5 Installation & Maintenance Manual
Function
SD Card
External Light
Coin detection sensor
Boot Mode
Fuse Voltage
Not mounted
Colour display with LDVS and Backlight
Printer power, Flowbird printer
Not mounted
Microphone
JTAG imx53
Not mounted
Not mounted
Page 41