Table of Contents
Advertisement
Switching actuator 2-gang / blind actuator, 1-gang 16 A with binary input, 3-gang
￭
Switch on the bus voltage or connect the bus again at the device. Release the
programming button only after the programming LED starts flashing slowly.
The safe-state mode is activated.
Deactivating safe-state mode
￭
Switch off the bus voltage (wait approx. 10 s) or carry out programming.
Master reset
The master reset restores the basic device settings (firmware remains in place). The
device must then be recommissioned with the GPA.
Performing a master reset
Precondition: The safe-state mode is activated.
￭
Press and hold down the programming button for > 5 s.
The programming LED flashes quickly.
The device performs a master reset, restarts and is ready for operation again
after approx. 5 s.
5
Technical data
Rated voltage
Current consumption
Connection mode
Outputs
Connection mode
Switching voltage
Switching current per device
Fluorescent lamps
Switch-on current 200 μs
Switch-on current 20 ms
Power consumption per output
Ohmic load
Capacitive load
Motors
Incandescent lamps
HV halogen lamps
HV-LED lamps
82404232
29.11.2022
DC 21 ... 32 V SELV
Device connection terminal on control
max. 16 A (140 μF)
5 ... 18 mA
cable
Screw terminals
AC 250 V ~
Σ 16 A
Σ 16 AX
max. 800 A
max. 165 A
2500 W
1380 VA
2300 W
2300 W
max. 400 W
11 / 17
Advertisement
Table of Contents
