Table of Contents
Advertisement
Switching actuator 2-gang / blind actuator, 1-gang 16 A with binary input, 3-gang
The safe-state mode is activated.
By briefly pressing the programming button again, the programming mode can
also be switched on and off in the safe-state mode as usual. If the program-
ming mode is active, the programming LED stops flashing.
Deactivating safe-state mode
￭
Switch off bus voltage (wait approx. 10 s) or carry out ETS programming.
Master reset
The master reset restores the basic device settings (physical address 15.15.255,
firmware remains in place). The device must then be recommissioned with the ETS.
In secure operation: A master reset deactivates device security. The device can then
be recommissioned with the device certificate.
Performing a master reset
Precondition: The safe-state mode is activated.
￭
Press and hold down the programming button for > 5 s.
The programming LED flashes quickly.
The device performs a master reset, restarts and is ready for operation again
after approx. 5 s.
Restoring the device to factory settings
Devices can be reset to factory settings with the Gira ETS Service App. This function
uses the firmware contained in the device that was active at the time of delivery (de-
livered state). Restoring the factory settings causes the devices to lose their physical
address and configuration.
5
Technical data
KNX
KNX medium
Commissioning mode
Rated voltage KNX
Current consumption KNX
Connection mode KNX
Outputs
Connection mode
Switching voltage
Switching current per device
82404232
29.11.2022
DC 21 ... 32 V SELV
Device connection terminal on control
TP256
S-mode
5 ... 18 mA
cable
Screw terminals
AC 250 V ~
Σ 16 A
11 / 13
Advertisement
Table of Contents
