Operation Instructions; Operation; Introduction; Operation From The Ground Control Box - Haulotte Compact 8 Operator's Manual

Compact 8 - Compact 8CU - Compact 8W - Compact 10 (Compact 2747E) - Compact 10N (Compact 2632E) -
Compact 10N-1 - Compact 12 (Compact 3347E) - Compact 14 (Compact 3947E)
D

- Operation instructions

Operation instructions

1 - Operation

1.1 - I
NTRODUCTION
Only trained and authorized personnel shall be permitted to operate this aerial work platform.
Prior to operation :
• Read, understand and obey all instructions and safety precautions in this manual and
attached to the aerial work platform.
• Read, understand and obey all local regulations.
• Become familiar with the proper use of all controls and emergency systems.
1.2 - O
PERATION FROM THE GROUND CONTROL BOX
• Turning "ON" and "OFF" of the machine is performed with selector key switch (92).
• Activation of a desired control box is achieved by turning the control box energizing selector
switch ( 92 ) to the desired position.
• The ground control box is energized and is active ONLY when :
• The emergency stop on the ground control box is not pushed in.
• The machine is switched on.
• Ground control box is selected.
• An E-stop button at each control box stops all movements when pressed in (deactivated).
N.B.-:-A
MACHINE
• An Enable Switch ( 9 ) provided must be activated and maintained to authorize one or more
function movements. If Enable Switch ( 9 ) is kept engaged without selecting a function
movement for more than 8 s; Enable Switch is automatically de-activated.
• The release of "Enable switch" ( 9 ) while performing a movement stops all the movements.
The stop of movements is progressive. If the Enable Switch system is re-pressed, the
movement doesn't restart. It could restart only when the selected function switch/joystick is
released to neutral position.
• All switches and joystick operating a movement, return automatically to neutral when
released.
• The ground control box is designed for maintenance and emergency rescue operations only.
Refer to
• The status of the switches is tested automatically when the machine is switched on, and
checked at every starting. A switch will be active only after it has been detected to be in
neutral position. The following switches are not controlled :
• Beacon light (if fitted)
4001182150
E-S
N TOP BUTTON PRESSED IN DOES NOT TURN OFF THE MAIN POWER SUPPLY TO THE
.
Section D 4.2 To rescue operator in platform.
E 08.21 USA / GB 77
A
B
C
D
E
F
G
H
I