Operation From The Platform Control Box - Haulotte Compact 8 Operator's Manual

Compact 8 - Compact 8CU - Compact 8W - Compact 10 (Compact 2747E) - Compact 10N (Compact 2632E) -
Compact 10N-1 - Compact 12 (Compact 3347E) - Compact 14 (Compact 3947E)
D
- Operation instructions
A buzzer beeps in the following conditions :
• Overload (if fitted).
• Machine out of stowed position and on a slope greater than allowable slope.
• Movements option.
• Indicators : All indicators are checked after powering on the machine
1.3 - O
PERATION FROM THE PLATFORM CONTROL BOX
• The platform control box can only be used if :
• The E-stop buttons on both ground and platform control boxes are not pressed in.
• Machine switched on at ground control box.
• Platform control box selected from ground control box.
• A faulty joystick is not taken into account to control a movement. If this fault disappears, the
movement is authorised again.
• An E-Stop button is present at each control box. When pushed in, it stops all functions
movements.
• An Enable switch ( 123 ) or Foot Switch in the basket ( 245 ) is present and should be
activated to authorize one or more function movements. If the Enable Switch is kept active
for more than 8 seconds without selecting a function movement, then movement is
disallowed. The enable switch must be released (reset) before movement can occur.
• The release of "Enable switch" ( 123 ) or Foot pedal switch in the basket ( 245 ) while
performing a movement stops all the movements. The stop of movements is progressive. It
could restart only when the selected function switch/joystick is released to neutral position.
• All switches and joystick operating a movement, return automatically to neutral when
released.
• The status of the switches and joysticks is tested automatically when the machine is
switched on. A switch or joystick will be active only after it has been detected in neutral
position.
A buzzer beeps in the following conditions :
• Overload.
• Machine elevated on a slope greater than the rated slope.
• Indicators - All the indicators are tested
• When the machine is switched on.
While driving on a slope :
• Always orientate the machine in the direction of the slope.
• Stow the machine completely.
• Do not travel down slopes in high speed.
• Do not drive fast in narrow or cluttered areas. Keep speed under control while making turns or sharp
bends.
78 4001182150 E 08.21 USA / GB