Falling Hazards - Haulotte Compact 8 Operator's Manual

Compact 8 - Compact 8CU - Compact 8W - Compact 10 (Compact 2747E) - Compact 10N (Compact 2632E) -
Compact 10N-1 - Compact 12 (Compact 3347E) - Compact 14 (Compact 3947E)
A
- Foreword

2.1.2 - Falling Hazards

To enter or exit from the platform :
• The machine must be completely stowed.
• Face the machine to access the entry opening to the platform.
• Keep 3 points of contact (both hands and a foot) on the steps and
the guardrail.
• Keep fingers away from moving parts near entry gate.
Before commencing operation :
• Ensure that guard rails are correctly installed and secured.
• Ensure that gate or sliding bar is in its securely locked position.
• If using a machine that has a swing gate, check that the entry gate
closes by itself and gate latches and locks.
• Remove oil or grease from the steps, floor, handrail and the guardrails.
• Clean the floor of the platform (no debris).
When in the platform :
• If local regulations require the wearing of a harness, use only the
anchor points provided for this purpose.
• The correct use of the harness requires the lanyard to be
connected to an anchorage point designated by the decals. Refer
to this decal located on the platform.
• Hold on securely to the guardrails.
• Always keep your feet firmly on the floor of the platform.
• Do not sit, stand, or climb on the platform guard rails.
• Do not lean on the gate or sliding bar.
• Do not lean over the guard rails or climb over them. Only work in
the platform area within the guard rails.
• Do not exit the platform until it is in the completely stowed position.
• Do not use the guardrail as a means of access to climb in or out
of the platform.
4001182150 E 08.21
x 1
USA / GB 11
A
B
C
D
E
F
G
H
I