Haulotte Compact 8 Operator's Manual page 100

Compact 8 - Compact 8CU - Compact 8W - Compact 10 (Compact 2747E) - Compact 10N (Compact 2632E) -
Compact 10N-1 - Compact 12 (Compact 3347E) - Compact 14 (Compact 3947E)
D
- Operation instructions
How to charge the batteries ? :
Before charging the batteries, switch the machine off.
• Use the machine's on-board charger. The charger has a charge rate compatible to the
battery capacity.
• Ensure that the mains supply is compatible to the charger's consumption.
• Top up the batteries with distilled water to the minimum electrolyte level if any of the
elements are below this minimum level.
• Work in a clean and well-ventilated area away from naked flames.
• Move the aerial work platform to a well-ventilated area with direct access to a AC electrical
outlet.
Charger type
Electric power supply
Delivered voltage
Charging time
Mains connection
How to maintain battery autonomy ? :
• Do not charge the batteries in cold temperatures.
• The battery life is reduced when the machine is used in cold temperatures (< 0 °C(32 °F) ).
• If the machine is not going to be used for a length of time, shut-off the power with battery
isolation switch(E-stop button ( 15 )).
• Do not let the battery discharge to below 20 %.
• If batteries are deeply discharged (<10%); standard battery charger may not be enough to
recharge battery.
To recharge the aerial work platform batteries :
Attach a 12 AWG multi-strand, grounded extension cord with a maximum length of 15 m (50
ft) to the receptacle located on the charger.
Plug the extension cord into outlet.
Start-up is automatic as soon as the mains connection is established. The charger is fitted with
a LED indicator placed near the special holding frame :
• Green indicator : Battery charged 100 %
• Yellow LED : Battery charged 80 %
• Red LED : Charger in the intitial charge phase
100 4001182150
24 V -
220 V single phase 50 Hz
Approx. 11 h (hours) for batteries discharged by 70 % to 80 %
Standard plug
E 08.21
24 V
USA / GB