Table of Contents
Advertisement
Step 2: Check the blade depth again by moving the cut-
ting head forward and back along the table insert
by making one complete cut.
8.4.1 Setting the Trenching Facility on the Model
KGZ 255 E
In its normally set position the trenching facility permits
the blade to cut completely through the work piece, but
when set the trenching facility allows the blade to cut
only part way through the work piece.
Step 1: Slide the stop plate (Pos. 1) towards the front po-
sition.
Step 2: Loosen the lock nut (Pos. 2) to free the lock knob
(Pos. 3), turn the stop knob down until the teeth
of the blade are at the desired depth.
Fig. 15: Setting the Trenching Facility
Step 3: While holding the upper arm in that position, tigh-
ten the lock nut to secure the stop knob.
Step 4: Recheck the blade depth by moving the cutting
head front to back through the full motion of typi-
cal cut along the control arm.
8.5 Operation of the laser modelKGZ
255 E
Turn on:
Press the on / off switch (30) to the "I" position to turn on the
laser (29). The laser line is projected onto the material to be
processed and provides an exact guide for the cut.
Turn off:
Push the On / Off switch (30) to the other position.
KGZ Series | Version 2.02 | EN
Operation the Chop- and Mitre Saw
8.6 Workpiece clamp
Model KGZ 210 E
When a workpiece is clamped, the board should always
be clamped with a screw clamp.
Model KGZ 255 E
To ensure optimum working safety, the workpiece must al-
ways be firmly clamped.
Do not saw workpieces that are too small to clamp.
When clamping the workpiece, do not reach with your fin-
gers under the clamping lever of one of the two clamps.
Step 1: Press the workpiece firmly against the stop (14).
Step 2: Insert the quick clamp (13) into one of the holes
provided.
Step 3: Adjust the quick release to the workpiece by tur-
ning the threaded rod.
Tighten the main screw to clamp the workpiece.
8.7 Table extension
Model KGZ 210 E
To support long workpieces, fix the side support rods
and adjust the length to support the workpiece. The miter
saw must be set up stable on a level and firm ground. It
is important to ensure that there is enough freedom of
movement to work.
CAUTION!
Risk of injury from an insufficiently secured saw!
Check the stability of the saw after mounting on stable
ground.
25
Advertisement
Table of Contents
