Table of Contents
Advertisement
Care, maintenance and repairs
9
Care, maintenance and re-
pairs
DANGER!
Risk of fatal injury through electric
shock!
There is a risk of fatal injury on touching live compo-
nents. Electrical components that are switched on
can perform uncontrolled movements and cause inju-
ries.
- Before starting cleaning and maintenance work, un-
plug the mains connector.
9.1 Care after finish work
Use protective gloves!
NOTE!
Never use strong cleaning agents for any cleaning
work. This can damage or destroy the device.
Step 1: Unplug the mains connector from the safety soc-
ket.
Step 2: Empty and clean the dust collection bag.
Step 3: Clean the saw from sawdust and chips.
Step 4: Check the saw for damage to the safety devices
and the saw blade. If necessary, repair or have
repaired the saw in accordance with the safety
instructions.
To ensure safe and proper operation, keep the power
tool and ventilation slots clean at all times.
The pull-back blade protection must always be able to
move freely and retract automatically. Therefore, always
keep the area around the return saw blade guard clean.
Remove dust and chips after each operation with a brush
or by blowing out with compressed air.
General inspection
Regularly check that all the fixing screws are tight. They
may vibrate loose over time. Check especially the outer
flange. If there is vibration, screws can loosen with time.
Regularly check the device's power cable and all exten-
sion cables used for damage. If the supply cord needs
replacing, the task must be carried out by the manufactu-
rer, the manufacturer's agent, or an authorized service
centre in order to avoid a safety hazard. Replace dama-
ged extension cables.
26
If the carbon brushes need to be replaced, have this
done by a qualified repair person
9.2 Replacement the Saw Blade
Use protective gloves!
Model KGZ 210 E
Step 1: Pull out the power plug from the grounded power
outlet.
Step 2: Push the release latch (28) towards the handle.
Press the control handle (3) down and pull the
release button (2) to release the saw arm (1).
Step 3: Raise the saw arm (1) to the highest position.
Step 4: Loosen the cover plate screw with a Phillips
screwdriver.
Step 5: Pull the shield of the rotating saw blade (6) and
turn it (6) over the upper fixed guard (4) to gain
access to the blade pin.
Step 6: Hold up the rotation guard (6) and press the
spindle lock knob (20). Turn the saw blade until
the spindle engages.
Step 7: Use the supplied 6mm hex wrench to loosen and
remove the saw blade screw. (Loosen clock-
wise as the knife screw has a left-hand thread).
Step 8: Remove the washer, the outer blade flange and
the saw blade. Remove sawdust and dirt from
the spindle and saw blade.
Step 9: Wipe a drop of oil on the inner leaf flange and the
outer leaf flange, where they touch the leaf.
Step 10: Place the new saw blade on the spindle, ma-
king sure the inner blade flange is behind the
saw blade.
Step 11: Reinstall the outer blade flange.
Step 12: Press the Spindle Lock Knob (20) and replace
the Washer and Blade Screw.
Step 13: Tighten the saw blade screw firmly with the 6
mm Allen key (tighten counterclockwise).
Step 14: Lower and hold the rotating lower blade guard
(6) and saw blade screw cover (8) to position
you. Replace the mounting screw and tighten to
secure the saw blade screw cover in place.
Step 15: Check that the blade guard is working properly
and cover the saw blade guard when the saw
arm is lowered.
KGZ Series | Version 2.02 | EN
Advertisement
Table of Contents
