Table of Contents
Advertisement
Mounting to a Working Surface (Model KGZ 255 E)
1. Attach the power tool to the work surface with suitable
screws. The mounting holes (10) serve.
2. Clamp the power tool with commercially available
screw clamps by the feet to the working surface.
Mounting to a Saw Stand (Model KGZ 255 E)
Any universal saw stand which will accept mounting ho-
les 450 mm. wide by 340 mm. in length will suffice.
Read all safety warnings and instructions included with
the worktable. Failure of observing safety warnings and
instructions can lead to electrical shock, fire and/or
cause serious injuries.
Assemble the worktable properly before mounting the
chop- and mitre saw. Perfect assembly is important in or-
der to prevent the risk of collapsing.
- Mount the chop- and mitre sawl in transport position
on the saw stand.
Fig. 7: Mounting holes, Model KGZ 255 E
7.2 Electrical Connection
DANGER!
Risk of death due to electric shock!
Contact with live components may result in fatal
injury. Switched-on electrical components can make
uncontrolled movements and lead to serious injuries.
Please make sure that the power connection has the
same characteristics (voltage, mains frequency, phase
position) as the motor. The information can be found on
the nameplate.
Step 1: Check that the cross-cut and mitre saw is swit-
ched off.
Step 2: Connect the saw to the mains.
KGZ Series | Version 2.02 | EN
Operation the Chop- and Mitre Saw
Use of an Extension Cable on the Model KGZ 255 E
If an extension cord is required, use an approved three-
wire extension cord suitable for powering the tool.
Grounded tools always require a three-core extension
cord.If the distance from the power outlet increases, you
must use a larger diameter extension cord. Using exten-
sion cords with inadequately sized cords will result in a
large voltage drop, resulting in a power failure and possible
damage to the equipment.The smaller the track number of
the wire, the greater the capacity of the cable. When using
a cable drum, always unwind the cable completely.
8
Operation the Chop- and Mitre
Saw
DANGER!
Risk of death due to electric shock!
Contact with live components may result in fatal
injury. Switched-on electrical components can make
uncontrolled movements and lead to serious injuries.
- Disconnect the mains plug before starting any adju-
stments to the chop- and mitre saw
WARNING!
Danger of life!
Failure to observe the following rules entails a risk of
injury for the operator and other persons.
- The chop- and mitre saw must be operated by one
trained and experienced person only.
- The operator must not work under the influence of
drugs, alcohol or medication.
- The operator must not work in case of tiredness or if
suffering from an illness that impairs concentration.
- The chop- and mitre saw must be operated by one
person only. Additional persons must keep out of
the work area during operation.
- In the case of a malfunction, switch off the saw and
disconnect it from the power supply. If necessary,
have it repaired by a qualified technician.
ATTENTION!
Risk of crushing!
Improper work on the machine may result in injury to
the upper limbs.
Wear hearing protection!
Use protective goggles!
17
Advertisement
Table of Contents
