Table of Contents
Advertisement
Operation the Chop- and Mitre Saw
Fig. 13: 45° Bevel Adjustment
Step 3: Loosen the bevel lock knob and tilt the cutting
head completely to the left. The mitre angle
scale must be at 0°.
Step 4: Using a combination square, check to see if the
blade is at a 45° angle to the table.
Step 5: If the blade is not at 45° to the table, tilt the cut-
ting arm to the right, loosen the lock nut (Pos. 3)
on the bevel angle adjustment bolt (Pos. 4) and
use a 5 mm. hex wrench to adjust bolt depth in or
out to increase or decrease the bevel angle.
Step 6: Tilt the cutting arm to the left to 45° bevel and re-
check for alignment.
Step 7: Repeat above steps until the blade is at 45° to
the table.
Step 8: Tighten bevel lock knob and lock nut when align-
ment is achieved.
Step 9: The right bevel 45° adjustment uses the same
sequence as the left bevel adjustment, just adju-
sting the adjustment bolt to 45° on the right.
8.3.4Bevel cut Model KGZ 255 E
With the chop saw, cross cuts from 0 ° -45 ° to the left
and 0 ° -45 ° to the right to the stop can be made.
Step 1: Loosen the turntable (25) by loosening the loc-
king screw (7) and the locking lever (8).
Step 2: Turn the turntable (25) and the scale pointer to
the desired angle setting on the adjusting
wheel (26) and lock it with the locking screw
24
(7). The saw has locking positions in angles of
-45 °, -30 °, -22.5 °, -15 °, 0 °, 15 °, 22.5 °, 30 °
and 45 °, in which the turntable (25) audible
locks.
Step 3: Tighten the locking screw (7) to secure the turn-
table (25).
Step 4: Cut as described above.
The saw blade can be positioned at any angle, from a 90
° straight cut (0 ° on the scale) to a 45 ° left / right miter.
8.4 Setting the Maximum Cutting Depth
(Model KGZ 210 E and KGZ 255 E)
The maximum depth travel of the cutting head has The
NOTE!
Switch off the saw and unplug the power cord as
soon as you make the following settings.
The maximum depth travel of the cutting head hasbeen
set at the factory. Check that the saw blade is free of move-
ment along the kerf by pressing the saw head down and
making the full movement of a cut along the table insert.
Turn the saw blade gently on the side to check the free mo-
vement of the saw blade. If the saw blade does not move
freely over the table insert, the saw may be damaged.
If the saw head does not move freely, make the follo-
wing settings:
Step 1: The cutting depth can be finely adjusted by turning
the screw (A). To do this, loosen the knurled nut
on the screw (A). Unscrew the screw (A) to tigh-
ten the knurled nut on the screw (A).
Fig. 14: Set cutting depth
KGZ Series | Version 2.02 | EN
Advertisement
Table of Contents
