Double Mitre Cut Model Kgz 255 E - Holzstar KGZ210 E Operating Instructions Manual

Step 6: Adjust the fence 90° to the blade and then tighten
the four fence locking bolts.
Step 7: After fence has been aligned, make a cut at 90°
using a scrap piece of wood and check square-
ness on the piece. Readjust if necessary.

8.3 Double mitre cut Model KGZ 255 E

With the chop saw miter cuts can be made to the left of 0
° -45 ° and to the right of 0 ° -45 ° in relation to the work
surface, whereby the turntable can be adjusted simulta-
neously from 0 ° -45 ° to left from 0 ° -45 ° to the right to
the stop rail (double miter cut).
Step 1: If necessary, disassemble the clamping device
(13) or mount it on the opposite side of the fixed
saw table.
Step 2: Move the machine head (19) to the upper posi-
tion
Step 3: Loosen the turntable (25) by loosening the loc-
king screw (7) and the locking lever (8).
Step 4: Adjust the turntable (25) with the handle (1) to
the desired angle.
Step 5: Tighten the locking screw (7) to secure the turn-
table.
Step 6: Cut as described above
8.3.190° (0°) Bevel Adjustment (Model KGZ 255
E)
Step 1: Loosen bevel lock knob (Pos. 1) and push the 0°
stop pin (Pos. 2) in. Tilt the cutting arm comple-
tely to the right. Tighten the bevel lock knob.
Fig. 11: 90° (0°) Bevel Adjustment
KGZ Series | Version 2.02 | EN
Operation the Chop- and Mitre Saw
Step 2: Place a combination square (3) on the table with
the ruler against the table and the heel of the
square against the saw blade.
Step 3: If the blade is not 90 ° square with the table, loo-
sen the bevel lock knob, put a 4 mm. hex wrench
into the hole (Pos. 4) located in the left side end
of the arm holder, turn the hex screw clockwise
or counterclockwise to make the blade square to
the table.
Step 4: Tighten bevel lock knob when alignment is achie-
ved.
8.3.290° Bevel Pointer Adjustment (Model KGZ
255 E)
Step 1: When the blade is exactly 90° to the table, loosen
the bevel indicator screw (Pos. 1) using a Phillips
screwdriver.
Fig. 12: 90° Bevel Pointer Adjustment
Step 2:Adjust bevel indicator (Pos. 2) to the "0" mark on
the bevel scale and retighten the screw.
8.3.345° Bevel Adjustment Left and Right (Mo-
del KGZ 255 E)
Step 1: Loosen the bevel lock knob (Pos. 1) and tilt the
cutting head completely to the left.
Step 2: Pull out the 0° stop pin (Pos. 2).
23