Table of Contents
Advertisement
Step 1: Pull the release button (2) and raise the saw arm
to its full height.
Step 2: Loosen the miter locks (18) and raise the miter
lock (19).
Step 3: Turn the miter table (14) until the pointer is aligned
with the desired angle on the miter scale (15).
Step 4: Release the miter lock (19) and retighten the
miter locks (18).
Step 5: Loosen the miter lock (10) and move the saw
arm (1) to the left to the desired tilt angle (bet-
ween 0 ° and 45 °). Tighten the tilt lock (10).
Step 6: Lay the workpiece flat with one edge securely on
the table (12).
When the board is warped, place the convex side
against the fence. If the concave side is placed against
the fence, the plate may break and block the blade.
When cutting long pieces of wood, support the opposite
end of the wood with the side support bars, a roll stand,
or a work surface that stands on the saw table.
Step 7: Before starting the saw, dry the cutting process
to make sure that there are no problems, such as cutting.
B. that a clamp affects the cutting process.
Step 8: Hold the control handle (3) firmly and squeeze
the switch lock (28) and the switch release (17) together.
Allow the blade to reach maximum speed and slowly lo-
wer it into and through the workpiece.
Step 9: Release the trigger switch (17) and wait until the
saw blade stops rotating before lifting the saw blade out
of the workpiece.
Step 10: Wait for the saw blade to stop before removing
the workpiece.
8.1.11Sawing wide boards on model KGZ 210 E
To cut wide boards, unlock the sliding lock knob (22) and
allow the cutting head to slide freely.
8.1.12 Setting the Cutting Depth (Model KGZ
210 E)
The depth of cut can be preset for repetitive straight cuts.
Step 1: Slide the trench stop (24) to the forward position.
Step 2: Loosen the trench depth lock nut (25) to release
the trench depth adjustment screw (23). Turn the
screw until the cutting head points down and un-
til the teeth of the saw blade are at the desired
depth.
KGZ Series | Version 2.02 | EN
Operation the Chop- and Mitre Saw
Step 3: While holding the upper arm in this position, tigh-
ten the Locknut (25) to secure the Incision Depth
Adjustment Screw (23).
Step 4: Recheck the blade depth by moving the cutting
head back along the control arm through the en-
tire typical cutting motion.
8.2 Adjustment Options on the Model
KGZ 255 E
8.2.1Setting the working position, Model KGZ
255 E
Step 1: Slide the tool arm slightly down the handle (1) to
relieve the locking pin (21).
Step 2: Pull the locking pin (21) fully outwards and turn
90 ° and release.
Step 3: Slowly raise the tool arm.
8.2.2Setting the Mitre Angle on the Model KGZ
255 E
Step 1: If a miter cut is required, unlock the table by tur-
ning the miter handle (1) counterclockwise.
Fig. 8: Model KGZ 255 E
Step 2: While holding the miter handle, raise the locking
lever (2).
Step 3: Turn the table with the miter handle to the right or
left.
Step 4: With the table in the desired position, as shown
on the miter scale (3), release the locking lever
and tighten the miter handle. The table is now
locked at the desired angle. Positive stops are at
0 °, 15 °, 22.5 °, 31.6 ° and 45 °
21
Advertisement
Table of Contents
