Table of Contents
Advertisement
Operation the Chop- and Mitre Saw
Wear safety boots!
Wear protective clothes!
For all cuts, make sure that the saw blade does not come
into contact with the stop, the screw clamps or other ma-
chine parts at any time. Remove any mounted help stops
or adjust them accordingly.
Protect the saw blade from shocks and damage. Do not
subject the saw blade to lateral pressure.
Do not saw shaped or bent workpieces. The workpiece
must always have a straight edge against the stop.
Long workpieces must be placed or supported at their
free end.
Position of the Operator
Do not stand in a line with the saw blade in front of the
machine. Always stand aside of the saw blade.
This protects your body against possible kickback.
Keep hands, fingers and arms away from the rotating
saw blade. Observe the following instructions:
Hold the work piece securely with both hands and press
it firmly against the saw table.
When sawing narrow work pieces and bevel angles, al-
ways use the supplied hold-down stick.
Adjusting the Cutting Angle (Model KGZ 255 E)
In order to ensure precise cuts, the basic setting of the
machine must be checked after extensive use and adju-
sted if necessary.
Always tighten the locking knobs (7) and (23) before sa-
wing. Otherwise, the saw blade may become wedged in
the workpiece.
Switching On the Chop- and Mitre Saw KGZ 255 E
To start the machine, press the ON/OFF switch (Pos. 2)
and keep it pressed.
NOTE!
For safety reasons, the ON/OFF switch (Pos. 2) can-
not be locked; it must remain pressed during the
entire operation.
18
Switching Off the Chop- and Mitre Saw KGZ 255 E
To switch off the machine, release the ON/OFF switch
(Pos. 2).
Release Knob (Model KGZ 210 E)
When boxed or during storage, transportation, the saw
head is locked in the down position.
Step 1: To get the head operational, slide the release
(28) towards the handle.
Step 2: Press the saw arm down and pull out the release
button (2).
Step 3: Turn the knob to unlock the saw head. The head
is gently raised to the upper position.
ATTENTION!
The saw must never be used when the head is loc-
ked over the lock button.
8.1 Adjustment Options on the Model
KGZ 210 E
8.1.1Mitre table Locks on the Model KGZ 210 E
The miter table latches (18) are used to lock the table at
the desired miter angle. The miter saw cuts from 0 ° to 45
° left and right. To set the miter angle, loosen the miter
table latches (18) (19) and turn the miter table to the de-
sired position.
The miter table has positive click-stops at 0 °, 15 °, 22.5
°, 30 ° and 45 ° for quick setting of common bevel
angles.
8.1.2Bevel Lock on the Model KGZ 210 E
The slope (10) is used to adjust the saw blade to the de-
sired angle of inclination. The miter saw cuts from 0 ° to
45 ° to the left. To set the chamfer angle, loosen the
chamfer lock and set the saw arm to the desired chamfer
angle.
8.1.3Spindle lock button on the Model KGZ 210
E
The spindle lock button (Pos. 20) prevents the blade in
the saw from rotating. Depress and hold the spindle lock
button while installing, changing, or removing the blade.
KGZ Series | Version 2.02 | EN
Advertisement
Table of Contents
