Table of Contents
Advertisement
Step 16: Connect the saw to the power supply and run
the blade to make sure it is working properly..
Model KGZ 255 E
Step 1: Disconnect the mains plug before working on the
device. Disconnect the device from the power
source.
Only use saw blades whose maximum permissible
speed is higher than the idle speed of the power tool.
Step 2: Adjust the locking pin to lift the cutting head.
Step 3: Loosen the cover plate screw (A) about 2 turns
with a Phillips screwdriver. Do not remove the
screw from the tool. Do not remove this screw
from the tool.
Fig. 16: Saw blade change model KGZ 255 E
Step 4: Lift the lower blade guard (4) and hold it up to ex-
pose the bolt with the threaded bolt.
Step 5: Press and hold the spindle lock knob (20) while
placing the hex wrench on the other side of the
flange screw while turning the saw blade until it
clicks into place.
Step 6: Continue to hold the spindle lock button to en-
gage it while turning the threaded stud clock-
wise with the wrench and removing the threa-
ded stud. Turn the flange screw to the right and
remove the outer flange.
Step 7: Remove the outer flange and the saw blade (18).
Wipe the flanges and spindle to remove dust
and dirt.
Step 8: Install the saw blade (18) in reverse order. Adjust
the arrow on the saw blade with the arrow on
the top blade cover. Make sure the blade teeth
point down.
Step 9: Place the outer flange against the saw blade and
onto the shaft. Screw the saw blade bolt coun-
terclockwise onto the shaft.
KGZ Series | Version 2.02 | EN
Care, maintenance and repairs
Step 10: Insert the saw blade wrench into the saw blade
screw.
Outer
Screw
Fig. 17: Saw blade change model KGZ 255 E
Step 11: Press and hold the spindle lock knob (4) while
turning the knife counterclockwise. If the
spindle lock clicks into place, push it further
while tightening the blade screw.
Step 12: Turn the lower blade guard back to its original
position until the slot in the cover plate snaps
into place with the cover plate screw.
Step 13: Hold the lower blade guard and tighten the
screw with a Phillips screwdriver.
Step 14: Make sure that the function of the protector
does not jam or stick.
Step 15: Verify that all equipment is properly installed
and in good condition before starting work.
DANGER!
Each time the saw blade is changed, it must be chec-
ked whether the saw blade turns freely and at an
angle of 45 ° in the table insert (6).
9.3 Electric brake modelKGZ 255 E
For safety reasons, the device is supplied with an electric
brake system for the saw blade. The device may there-
fore generate sparks when it is turned off. This does not
affect the performance or safety of the device.
9.4 Maintenance and repairs
Maintenance and repairs must be carried out by specia-
list staff only.
If the chop- and mitre saw is not operating correctly, con-
tact a specialist retailer or our customer service. The
contact details can be found in chapter 1.2 Customer
Service.
Saw blade
spindle shaft
Inner flange
27
Advertisement
Table of Contents
