Pitney Bowes SendPro HVF1 User Manual page 12

Getting Started
12. The thickness adjustment knob is located beneath the feeder cover. Turn this knob to adjust for
the thickness of the envelopes. To set, turn the knob until the arrow on the knob lines up with the
arrow to the right as shown below. The arrow on the knob snaps into position.
SendPro MailCenter, SendPro MailCenter and SendPro MailCenter devices:
l
Setting 1: Use this setting for postcards mailpieces that are 0.007 inches (0.18 mm) to
l
0.375 inches (9.52 mm) thick
Setting 2: Use this setting for mailpieces that are greater than 0.375 inches (9.52 mm)
l
to the maximum of 0.625 inches (15.9 mm) thick
SendPro MailCenter devices:
l
Setting 1: Use this setting for postcards and mailpieces that are less than 0.25 inches
l
(6.35 mm) thick
Setting 2: Use this setting for mailpieces that are greater than or equal 0.25 inches
l
(6.35 mm) thick, but less than 0.50 inches (12.7 mm) thick
Setting 3: Use this setting for mailpieces that are greater than or equal to 0.50 inches
l
(12.7 mm) thick, but less than 0.625 inches (15.9 mm) thick
Setting 4: Use this setting for mailpieces that are greater than or equal to 0.50 inches
l
(12.7 mm) thick, but less than 0.625 inches (15.9 mm) thick
13. The moveable side guide at the front of the feed deck is used to stabilize the envelope position
when feeding it. Note that the side guide is optional feature on SendPro MailCenter devices.
14. The power button turns the device on and off. This is located on the lower left side of the feed
deck.
15. The feed deck is the area where you load the envelopes. If you have a SendPro MailCenter,
SendPro MailCenter or SendPro MailCenter system, this feeds the envelopes to the WEIGH-
ON-THE-WAY® (W-O-W®) transport deck.
Pitney Bowes User Guide January 2023 12