Table of Contents
Advertisement
4.11 Maintenance procedure
When required
Replace bucket teeth (Horizontal pin type)
Replace the point before the wear reaches the adapter.
WARNING
It is dangerous if the work equipment moves by mistake
when the teeth are being replaced. Set the work equipment
in a stable position, then stop the engine and raise the safety
lock lever to the LOCK position.
If the locking pin is knocked out with excessive force, there is
a hazard that the pin may fly out. Check that there is no one
in the surrounding area.
Pieces will often fly during the replacement operation, so
wear safety glasses, gloves, and other protective equipment.
1. Set the bottom of the bucket on a block to make it possible to
remove pin (1), check that the work equipment is stable,
then raise the safety lock lever to the LOCK position.
Set so that the bottom of the bucket is horizontal.
2. Place a bar on the pin head and strike the bar with a ham-
mer to knock out pin (1). Remove tooth (2).
REMARK
Use a round bar with a smaller diameter than that of the pin.
3. Clean the mounting face. Fit a new tooth (2) in the adapter,
push in pin (1) partially by hand, then lock it with a hammer
to install the tooth to the bucket.
4-52
Lock
Unlock
2
2
PW180-7E0 – VEAM400102
Maintenance
Block
1
GK018400
1
GK018401
Advertisement
Table of Contents
