Table of Contents
Advertisement
Operation
Pilot display
When the starting switch is ON, the pilot display lights up when
the display items are functioning.
1. Engine pre-heating monitor
This monitor lamp (1) indicates the pre-heating time required
when starting the engine at an ambient temperature below 0°C.
The monitor lamp lights when the starting switch is turned to the
HEAT position and flashes after about 30 seconds to show that
the pre-heating is completed.
(The monitor lamp will go off after about 10 seconds)
2. Swing lock monitor
This monitor (2) informs the operator that the swing lock is being
actuated.
Actuated: Lights up
When the swing lock switch is turned ON (ACTUATED), the
monitor lamp lights up.
This monitor flashes when the swing holding brake cancel
switch is turned on.
REMARK
The swing motor is equipped with a disc brake that mechanically
stops the rotation. When the swing lock monitor lamp is lit up,
the brake remains applied.
3. Auto-deceleration monitor
This monitor (3) shows if the auto-deceleration function has
been actuated.
The monitor display when the auto-deceleration switch is oper-
ated is as follows.
Auto-deceleration monitor ON: Auto-deceleration actuated.
Auto-deceleration monitor OFF: Auto-deceleration canceled.
PW180-7E0 – VEAM400102
3.3 Basic check items
GK018130
GK018131
GK018132
3-19
Advertisement
Table of Contents
