Table of Contents
Advertisement
Operation
2. Remove dirt from around engine, radiator, battery
Check that there is no dirt accumulated around the engine,
battery or radiator. If any dirt is found, remove it. Also check
for flammable material (rags, leaves, twigs, grass etc.) and
remove.
3. Check for leakage of water or oil around engine
Check that there is no leakage of oil from the engine or leak-
age of water from the cooling system. If any abnormality is
found, repair it.
4. Check for oil leakage from hydraulic equipment, hydrau-
lic tank, hoses, joints
Check that there is no oil leakage. If any abnormality is
found, repair the place where the oil is leaking.
5. Check for damage to wheels and tyres
6. Check for damage to handrail and for loose bolts
Repair any damaged handrails and tighten any loose bolts.
7. Check for damage to monitor and loose bolts
Check that there is no damage to the monitor in the opera-
tor's cab. If any abnormality is found, replace the parts.
Clean off any dirt on the surface.
8. Clean rear view mirror, check for damage
Check that there is no damage to the rear view mirror. If it is
dam-aged, replace it with a new mirror. Clean the surface of
the mirror and adjust the angle so that the view to the rear
can be seen from the operator's seat.
9. Check lifting eye for damage
Check the lifting eye (or hook and safety latch) for damage.
If damage is found, contact your KOMATSU distributor for
repair.
10. Check seat belt and mounting clamps
Check there is no abnormality in the seat belt or mounting
clamps. If there is any damage, replace with new parts
PW180-7E0 – VEAM400102
3.23 Operation
3-97
Advertisement
Table of Contents
