13. Power Up and Installation Completion
Initial System Checkout and Preparation for Power Up
Before Installing Rectifiers
Prior to installing rectifiers, verify that the correct ac voltage is present at the AC connectors in the
rectifier shelves.
Note: Disregard if this was done as part of the "AC Connection and Wiring" procedure.
Safety Reminder
Some of the following procedures are performed while ac voltage is present at the cabinet; exercise
extreme caution and observe all precautions described in the safety section of this product manual.
Controller Front Panels
Illustrations
Refer to the following figures for illustrations of the controller front panels:
Figures 13-1 Millennium II Controller
Page 132
© Copyright 2021 ABB. All rights reserved.
Figure 13-1: Galaxy Millennium II Controller Front Panel, Round