12. Connection of Office Alarms
Introduction
This section explains the installation procedure to connect the office alarms.
Connecting Controller Alarms
Step
Choose the appropriate illustration from the following list:
·
Figure 12-1: Millennium II Controller with Insulation Displacement Alarm Board
·
Figure 12-2: Millennium II Controller with Wire Wrap Alarm Board
Route wires (installer provided, 22-gauge maximum) from the office alarm block back to the controller by
Millennium II
Page 130
© Copyright 2021 ABB. All rights reserved.
Connecting Office Alarms
Figure 12-1: Millennium II Controller with Insulation Displacement Alarm Board
Action