Table of Contents
Advertisement
7.3.2
Resetting all JOBs
Display
7.4
General operating problems
Problem
Machine control without displaying the signal
lights after switching on
no welding performance
various parameters cannot be set
099-005033-EW501
15.01.2010
JOB-
LIST
m /m in
Setting/selection
Reset to factory settings
The RESET will be done after pressing the button.
The menu will be ended when no changes are done after 3 sec.
Figure 7-2
Possible cause > remedy
•
Phase failure > check mains connection (fuses)
•
Phase failure > check mains connection (fuses)
•
Entry level is blocked > disable access lock (see
chapter entitled "key switch", if available)
Rectifying faults
General operating problems
JOB-
LIST
83
Advertisement
Table of Contents
Need help?
Do you have a question about the Taurus 301 KGE and is the answer not in the manual?
Questions and answers