Main Program A Mode - EWM Taurus 301 KGE Operating Instructions Manual

5.8.13 Main program A mode

Different welding tasks or positions on a workpiece demand various welding performances (operating
points) or welding programs. The following parameters are stored in each of the up to 16 programs:
• Operating mode
• Welding type
• Superpulses (ON/OFF)
• Wire feed speed (DV2)
• Voltage correction (U2)
• Dynamics (DYN2)
Example 1: Welding workpieces with different sheet metal thicknesses (non-latched)
Example 2: Welding different positions on a workpiece (latched)
Example 3: Aluminium welding of different sheet metal thicknesses (non-latched or latched
special)
Up to 16 programs (P
An operating point (wire speed, arc length correction, dynamics/choke effect) can be defined
permanently in each program.
Program P0 is an exception: the settings for operating points are made manually here.
Changes to the welding parameters are saved immediately!
099-005033-EW501
15.01.2010
I
P
A0
P
A1
I
P
A2
P
A0
I
P
A1
P
A0
to P ) can be defined.
A0 A15
Design and function
P
A9
P
A8
P
A1
Figure 5-30
P P
A3 A3
P P
A4 A4
Figure 5-31
P
A9
P
A8
Figure 5-32
NOTE
MIG/MAG welding
t
P
A5
t
t
57