Operation With Chromeleon; Connecting To Chromeleon - Thermo Scientific Dionex UltiMate 3000 Series Operating Instructions Manual

5.3 Operation with Chromeleon

Before you begin, verify that
1. The Chromeleon software is installed on the computer and the license code is entered.
2. The pump is connected to the Chromeleon data system computer by means of an USB
connection.
3. The pump is set up in Chromeleon, as described in section 3.5 (→ page 45).
Before you can operate the pump with Chromeleon, you have to connect the timebase in
which the pump is installed to the Chromeleon client program (→ section 5.3.1).
Two modes of software control are available:
• Direct control with the parameters and commands in the Commands dialog box
(→ page 70) or on a control panel (→ page 71).
Automated control with a control program (PGM) (→ page 72).
•

5.3.1 Connecting to Chromeleon

1. Start the Chromeleon Server Monitor and the Chromeleon server if they are not yet
running (→ page 45).
2. Start the Chromeleon client by clicking the Chromeleon icon
If the Chromeleon icon is not on the desktop, click Start on the taskbar, point to
Programs (or All Programs, depending on the operating system), point to Chromeleon,
and then click Chromeleon.
3. Connect the Chromeleon client program to the timebase in which the pump is
installed. For details about how to do this from the Commands dialog box, see
page 70. For details about how to do this on a control panel, see page 71
When the pump is correctly connected to Chromeleon:
• The Connected LED on the front panel is green.
• Functions for estimating the lifetime of consumables and monitoring and recording
service and (re)qualification information are provided (→ page 86).
• The Standby button on the front panel remains active.
Before turning off the pump by the main power switch, always disconnect the pump in
Chromeleon.
Operating Instructions
UltiMate 3000 Series:
LPG-3400XRS Pump
on the desktop.
Page 69